Page 1 of 1
Separate PC mod?
Posted: Mon Apr 30, 2007 10:19 pm
by The Stealthy Panda
Yeah, I was just wondering, is there some mod I can do to turn a PR into a Separate PC gun?
Posted: Mon Apr 30, 2007 10:27 pm
by C-A_99
It's usually more worth it to do a homemade or buy a sep. PC gun.
However, the closest to this was someone's vaporizer with homemade internals and LRT installed. Look around the articles section of the site for it. (can't find it right now)
Posted: Mon Apr 30, 2007 10:47 pm
by Silence
Ben's
piston conversion mod turned a Vaporizer into a separate PC gun. However, the Vaporizer is a piston gun, not a PR gun. Croc and mr. dude started a mod of this type to an
EES Turbine. There's a bit more info on their site.
However, I agree that in most cases, it's not worth it to convert a PR gun to a separate PC water gun. Which water gun did you have in mind?
Posted: Mon Apr 30, 2007 11:50 pm
by The Stealthy Panda
A Max-d 3000. You know, now that I think of it, it wouldn't be too hard, just attach a new reservoir to the pump intake, and use the old reservoir as the PC. Maybe epoxy on the cap or something.
Posted: Tue May 01, 2007 12:46 am
by Silence
That actually sounds like it would work well. But consider the results. You'd have a large PC (large enough to warrant the use of a separate reservoir) sticking out the bottom of the gun, unless you used a backpack - which would have a neat effect.
I don't know how the intake check valve on the Max-D 3000 works, but many systems that pump air have
special pumps that take in air from the atmosphere as you pull the pump out. It would be difficult to convert a system like that to take in water. However, if the Max-D 3000 just uses regular check valves, then your idea would work.