Page 1 of 1
Posted: Sat Jan 15, 2005 7:16 pm
by DX
Nibordude and I are making a check valve freeze and k-modding video now. We are using a CPS 1200, but we need to get it open. Nibordude has gotten the screws out, but the casing won't open because of the nozzle. How do you get the nozzle of the 1200 off?
Posted: Sat Jan 15, 2005 8:01 pm
by Commander_Gaunt
Like a lot of guns, the CPS 1200 has a nozzle surround bit which makes the thing a real ****** to open, You can't actually do much about it short of sawing it off. Like the XP 110, there is no way I have found to prise off the nozzle casing. If you need a fully open casing then I would suggest a different gun unless you don't mind sawing most of the front off. Not much help I know, but that is the way it is.
Posted: Sat Jan 15, 2005 9:25 pm
by DX
After a lot of sawing we were able to pry sections off until finally we could get the gun open. It's done, and the videos are being edited by Nibordude [hopefully right now].
Posted: Sun Jan 16, 2005 3:03 am
by NiborDude
Yeah, we got it open. I cut myself doing so. Man it hurt. We ended up ripping off the front of the nozzle. The vids should be up on SM in a couple days.