opening 2100

Threads about water gun modifications.
Locked
User avatar
Hunt_and_Annoy
Posts: 404
Joined: Sat Feb 12, 2005 1:00 pm

Post by Hunt_and_Annoy » Tue Mar 01, 2005 12:35 am

can someone tell me how to get the cap on the front of the pump off?

User avatar
wetmonkey442
Posts: 320
Joined: Sun Jun 22, 2003 12:00 pm

Post by wetmonkey442 » Tue Mar 01, 2005 12:34 pm

This question has been asked about 20 times, and if you just check some old topics you would have found the answer. On the Mark I you just twist it off, on the Mark II and III you have to cut it off.
Join the fight! Support water warfare in your area today!

User avatar
DX
Posts: 1780
Joined: Wed Feb 04, 2004 1:00 pm

Post by DX » Tue Mar 01, 2005 8:56 pm

Er..Marks 1 and 3 you can just twist it off. The Mark 2 is the only one you have to saw/cut off. This question has been asked and answered so many times in the past and is even answered in one of the pinned topics in this forum!
Mess With the Best, Get Soaked Like the Rest!

2004 Red Sox - World Series Champions
2007 Red Sox - World Series Champions!

User avatar
Hunt_and_Annoy
Posts: 404
Joined: Sat Feb 12, 2005 1:00 pm

Post by Hunt_and_Annoy » Fri Mar 04, 2005 4:11 am

according to the article on CPS 21000, I have a mark 3, the pump cap turns, but dosen't twist off :huh:

User avatar
NiborDude
Posts: 683
Joined: Sun May 23, 2004 12:00 pm

Post by NiborDude » Fri Mar 04, 2005 4:31 am

Take a flat head screwdriver and shove it under the pump cap. Apply lots of pressure and eventually it will slowly come off. As a side not, when I put the pump cap back on I Don't push it on all the way to where it's tight as before. That way you don't have to take out the screwdriver again. B)
Image

<span style='color:EEF2F7'>Blinding ignorance does mislead us. O! Wretched mortals, open your eyes! -Leonardo Da Vinci

Locked