A.R.M. 4000 XL Review
Well, I drilled the nozzle on my ARM, and it had little effect at first, so I tried the next bit size, and my stream is too weak. So, I decided I needed to do a Collosus on it.
PC From Side
Pc From Front
It measures 3 7/8" in length, with a 1 1/8" OD and a 3/4" ID (thickness of 3/8").
Also, I managed to find out how to do a PRVD on it. Not that anyone owns one of these things, but here it is anyways.
Valve, pump shaft, and pipe nipple for PC
Here's the piece you'll need. What you do is detach the Biceptor piece, and carefully saw off the purple cap where the hose attatches.
The cap is at the top and left of the gun in this image.
Unscrew all of the screws on the biceptor, and pull out the assembly. You can easily remove the PC clamps, too.
To do a PRVD on this, saw at the red line shown here.
Be careful, so that you don't damage any of the tubing inside like I did. (I can fix it!)
Finally, Put some epoxy on the black dot in the red box here.
Now close the assembly up with some waterproof, pressure-proof epoxy.
Well, If you ever get one of these thing, you now know how to do a PRVD on it. Oh, and anyone who wants to use this on their site can, just give me credit for doing it.