Ok, so here's the information you may want to know:
I was trying to shoot my splat blaster, and it wouldn't shoot. I checked the trigger plug at the front of the gun, and that the reservoir had water in it. The gun would not shoot, but would make the clicking noise, and I could cock it perfectly fine. However, no water came out, or when it did, it was nowhere near what I had remembered.
I opened the gun up, to find the problem, and after taking it apart, noticed that there was a crack in the piece that cocked the plunger back. I tried using simple plastic glue, but that failed, as I could easily pull it apart after it sat for over a day. I have epoxied it, and will check it's strength later.
I've done this to nerf guns before (Namely the Maverick, after power modding it), when the pulling piece separated it from the metal rod that pulled the plunger back. Would this give similar effects, or would it be a bad idea?
Splat Blaster repair
- CROC
- Posts: 302
- Joined: Fri Mar 31, 2006 10:03 pm
Splat Blaster repair
-Croc
It's been a while guys, and its good to be back
It's been a while guys, and its good to be back
- Silence
- Posts: 3825
- Joined: Sun Apr 09, 2006 9:01 pm
Re: Splat Blaster repair
Use a metal strip to reinforce the piece like in the snapped trigger repair. If the problem is more complicated, a picture or two would help.
Good luck!
Good luck!