I'm getting a lot of leaking out of the handle, and pump. I'm going to epoxy/silicone the insides of the gun, but I was wondering if I could misalign a PC and cause more leaks, any advice would be appreciated.
Thanks,
--Botts
XP95 Leaks
- SSCBen
- Posts: 6449
- Joined: Sat Mar 22, 2003 1:00 pm
Welcome to SSCentral!
If that is your problem, then it is more than likely a leak from the pump. The seal must be inadequate. The best thing to do would be to open it up to see what's going on from that side.
Don't worry about misaligning the PC or anything. They don't make these water guns that delicate probably because if they did, they'd have a lot more problems.
Also remember our Repairs Template which lists some information we should see to help you out.
If that is your problem, then it is more than likely a leak from the pump. The seal must be inadequate. The best thing to do would be to open it up to see what's going on from that side.
Don't worry about misaligning the PC or anything. They don't make these water guns that delicate probably because if they did, they'd have a lot more problems.
Also remember our Repairs Template which lists some information we should see to help you out.
- perilous1
- Posts: 79
- Joined: Sun Apr 10, 2005 1:22 am