I think I heard this somewhere but if you glue the bottom part of the quickfill cap thats actualy a check valve tipe thing.
Im not sure if it has much of an effect but you can tell it did something from the stream because its broken up,then is laminated.
cvf on liquidator
-
- Posts: 257
- Joined: Tue Aug 31, 2004 12:00 pm
- RacerSoaker445
- Posts: 951
- Joined: Sun Mar 14, 2004 2:27 pm
The QFC(quick fill cap) is a check valve, it allows water and pressure to only go one way. When you put water into it, the water goes into the reservoir, so putting glue on it won't help any.
The Liquidator and HydroBlade are PR guns, they work like a Max-D gun, and in a way, the Liquidator is the 2004 version of a Max-D gun, it uses the same checkvalve-pump and trigger valve system as a MD gun.
To CVF the Liquidator, do this.
The Liquidator and HydroBlade are PR guns, they work like a Max-D gun, and in a way, the Liquidator is the 2004 version of a Max-D gun, it uses the same checkvalve-pump and trigger valve system as a MD gun.
To CVF the Liquidator, do this.
I don't check this forum anymore.
- Neuro
- Posts: 1081
- Joined: Thu May 01, 2003 12:00 pm
-
- Posts: 257
- Joined: Tue Aug 31, 2004 12:00 pm
- Neuro
- Posts: 1081
- Joined: Thu May 01, 2003 12:00 pm
-
- Posts: 5
- Joined: Thu Aug 26, 2004 1:30 am
Actually you don't need to glue a thing (at least with the hydroblade). there is a little screw on the other side that u can tighten (it tightens the spring that releases the pressure) so that it won't release any pressure. I did this and the front of the hyroblade blew off after pumping for awhile.